Troubleshooting - weinor BiLine Combio-868 MVLED Assembly And Installation Instructions Manual

BiLine Combio-868 MVLED/ MLED
5

Troubleshooting

Type of fault
Awning/light does not react to
the signal sent by the hand
transmitter
Drive moves in wrong direction
Following a DOWN command,
awning extends only a short
way, then immediately retracts
Awning moves UP and cannot
be halted or extended
Following an UP command,
the awning stops after a while
then continues
The awning cannot be
taught in
a) with the BiEasy hand
transmitter
b) with the Remoto hand
transmitter
Table 3: Troubleshooting
Item number 116692-0000
Version 2 15.11.2013
Cause
•
No power supply
•
Awning/light has not
been programmed
•
Empty batteries in hand
transmitter
•
Directions have been
programmed incorrectly
•
Receiver is in lock mode:
maximum wind factor on
sun/wind or sun/wind/rain
sensor exceeded
•
WeiTronic Agido-868
product protection sensor
has been triggered in last
few minutes
•
Programmed sun/wind or
sun/wind/rain sensor is
faulty or incorrectly
installed
•
"Wind alarm":
Programmed sun/wind
and/or sun/wind/rain
sensor or Agido-868
product protection sensor
has been triggered
•
Agido-868 battery empty
a) the unidirectional
transmitter/ sensor
e.g. Remoto is still
taught in
b) the bidirectional
transmitter/ sensor
e.g. BiEasy is still
taught in
We reserve the right to make technical
changes
Page 9/28
Assembly and installation instructions
Remedy
•
Reconnect power supply
•
Program awning/light
•
Replace batteries
•
Delete channel and
program correctly
•
Lock mode is removed
automatically 15 minutes
after the maximum wind
factor was last exceeded
•
The device unlocks
automatically after 15-20
minutes
•
The device will only unlock
when the fault has been
remedied
•
The device unlocks
automatically after the
designated period
•
Replace batteries in a
programmed WeiTronic
Agido-868 product
protection sensor
•
delete old transmitter
completely then teach in
the awning with the new
transmitter