Victron energy SmartSolar MPPT 75/10 Manual page 32

Setting up the network
When setting up the network, first set up the Smart Battery Sense or battery monitor, and then add one or more solar chargers or
AC chargers to the network.
All solar chargers and AC chargers need to have the same charge settings. The easiest way to do this is to use a preset battery
type or a saved used defined battery type. A warning #66 message will be shown if there is a difference between the devices
charge settings.
To set up a new network:
• Open the VictronConnect app.
• Select one of the devices that needs to become part of the new VE.Direct network.
• Navigate to the settings page by clicking the gear
• click on "VE.Smart Networking".
• Click on "create network".
• Enter a name for the new network.
• Click "save".
• Wait for confirmation that the network has been set up and click "OK".
• If more devices need to be added to this network go to next paragraph and join multiple devices to the network.
To join another device to an existing network:
• Open the VictronConnect app. Select a device that needs to become part of a VE.Direct network.
• Navigate to the settings page by clicking the gear
• Click on "VE.Smart Networking".
• Click on "join existing".
• Select the network the device needs to be joined to.
• Wait for confirmation that the network has been set up and click "OK".
• Repeat above steps if more devices need to be added to the network.
To leave a network:
• Open the VictronConnect app.
• Select a device that needs to be removed from the VE.Direct network.
• Navigate to the settings page by clicking the gear
• Click on "VE.Smart Networking".
• Click on "leave network".
Check the network
Once the network has been set up all devices communicate with each other. The active LED on the each connected device will
now blink every 4 seconds. This is an indication that the device is actively communicating with the network.
To check if an individual device is communication with the network, click on the VE.Smart symbol
the solar dail. A pop-up window will open showing teh connection status and the shared parameters.
Page 28
MPPT solar charger manual
symbol.
symbol.
symbol.
in the main screen next to
Configuration and settings