Maximum MS20300 Instruction Manual page 18

34
model no. 055-9036-2 | contact us 1-888-670-6682 model no. 055-9036 | contact us 1-800-689-9928
SLIDE STOP (FIG. 16)
The slide lock places the saw in a position to
maximize cutting of base molding when cut
vertically.
• Unlock the head lock pin and raise the saw
head assembly.
• Turn the slide stop (1) toward front counter-
clockwise.
• Unlock the slide lock knob.
• Grasp the switch handle and pull the saw
head assembly backward to the rear of the
saw until saw head assembly comes in
contact with the slide stop.
• Lock the slide lock knob.
• If needed, turn the slide stop (1) toward back
clockwise to temporarily disable it.
BACK FENCE KNOB (FIG. 17)
Your saw can cut very wide (up to 7 1/2"
[19 cm]) crown molding workpieces when the
back fence knobs are used.
• Unlock two fence lock knobs (1) on the rear
of the fence.
• Remove both left and right sliding fences (2)
from the saw.
• Turn four back fence knobs (3) from the
horizontal position to the vertical position.
1
Fig. 16
2
3
3
1
Fig. 17
When transporting the mitre saw, turn off and unplug the saw, then lower the saw head
and lock it in the "DOWN" position. Always use the carrying handle when lifting the saw.
WARNING!
To avoid injury from an accidental start, make sure the switch is in the OFF
position and the plug is not connected to the power source outlet.
WARNING!
Never cut metals or masonry products with this tool. This mitre saw is designed
for use on wood and wood-like products only.
WARNING!
To reduce the risk of serious personal injury, always wait for the blade to stop
completely, turn off the tool and disconnect it from the power source before attempting
to move it, change accessories or make any adjustments.
WARNING!
To reduce the risk of injury, wear safety goggles or glasses with side shields.
WARNING!
Before each use, verify that the blade is free of cracks, loose teeth, missing teeth,
or any other damage. Do not use if damage is observed or suspected.
BODY AND HAND POSITION
Starting a cut:
• Place hands away from the cutting path of the blade.
• Hold workpiece firmly against the fence to prevent movement toward the blade.
• With the power switch OFF, bring the saw blade down to the workpiece to see the
cutting path of the blade.
• Squeeze trigger switch to start saw.
• Lower blade into workpiece with a firm downward motion.
Finishing a cut:
• Hold the saw head in the down position.
• Release trigger switch and wait for all moving parts to stop before moving your hands
and raising the saw head.
• Unplug the mitre saw.
WARNING!
Never place hands near the cutting area. Proper
positioning of your body and hands when
operating the mitre saw will make cutting easier
and safer. Keep children away. Keep all visitors
at a safe distance from the mitre saw. Make sure
bystanders are clear of the saw and workpiece.
Do not force the saw. It will do the job better
and safer at its designed rate.
35