Atlantic 2012 Installation And Operating Manual page 19

Heating and drying towels: how to use the 24h Auto Drying function.
To activate the 24h Auto Drying function, set the mode selection wheel A to
Light B comes on.
Your device operates at medium power for 2h 15 min and then stops heating (the device remains ON).
You can deactivate the function at any time with a 1-second press on the selection wheel A.
The 24h Auto drying function will repeat the cycle every day of the week at the same time.
The second time that the 24h Auto drying function starts up will be the following day, 45 minutes
before the time programmed when you first activated the function and then at the same earlier time
every day of the week.
Example of use:
You wish to have warm towels at 7 AM.
On the first day, at 7AM, set the mode selection wheel A to
power for 2h 15 min and then stops (it remains ON).
On the following day and the days thereafter, your device starts to heat at medium power at 6:15
AM to heat your towels for 7 AM and then dry them afterwards until the end of the 2h 15 min period.
To activate the 24h Auto Drying function outside the programmed time, hold down the mode selec-
tion wheel A for 1 second.
You can deactivate this function at any time before the 2h 15 min period has expired by pressing the
selection wheel A.
Light B comes on.
Your device operates for 2h 15 min and then stops heating.
To deactivate the 24h Auto drying function, change the position of the mode selection wheel A. Your
device resumes normal operation. The 24h Auto Drying function is deactivated.
Locking the controls: how to use the Locking function
This function enables you to lock the heating mode you have selected (e.g.: mode ON, temperature set
with the wheel on
To activate the Locking function, hold down the mode selection wheel A for more than 3 seconds
(the wheel may be at any position except OFF).
Light B flashes 5 times: the settings are locked.
The selected temperature cannot be altered.
You can still use the 2h Boost function by pressing wheel A (if the wheel A were set to ON or
To switch off the Locking function, hold down the mode selection wheel A for more than 3 seconds.
Light B flashes 5 times: the settings are locked.
You can change the position of the mode selection wheel A but any changes will not be regis-
tered.
- If you change the position of the mode selection wheel A, light B flashes.
- If you change the position of the temperature setting wheel D, the temperature will not
change.
). It is used to prevent any untimely operation of the device (by children, etc.).
. Your device starts to heat at medium
18
.
).