Atlantic 2012 Installation And Operating Manual page 15

2) How to install the device ?
1 Unfasten the flaps on the lid and position it against the
wall with the lower flap folded back and placed on the
floor or at the desired installation height. Mark off the 4
drill holes through the packaging, without drilling them,
and then remove the packaging.
Power
500 W
750 W
1000 W
Model
width
400 mm
2 Carefully mark the 4
drilling points with a
pencil (draw a cross,
2cm wide).
Drill the 4 holes.
Note: The pins sup-
plied with the device
are of the standard
type. In case of a parti-
cular stand, use appro-
priate pins.
4 Screw
the
pins on the
t u b e s
w i t h o u t
locking them.
Check they
are correctly
p o s i t i o n e d
by inserting them in the sleeves, with the
device. After finding the right position, tighten
the screws on each pin.
Measurement (A)
779
1230
1599
Power
Measurement (A) Measurement (B)
300 W 574
500 W 1025
750 W 1476
Measurement (B)
350
400
270
3 Screw
sleeve in place.
Fit the screws
with
washers provi-
ded.
5 Place
device on the
wall, in the
s l e e v e s .
Tighten all the
l o c k i n g
screws. Fit the
caps on the
ends of the pins.
14
B
361 mm
SOL
the
the
the
A