Selecting Configuration Options For The Serially-Controlled Sifm; Figure 1 Dip Switch Locations The Control Boards Of The Serial Controlled Ils (Sifm Shown); Table 1 Switch Settings On The Control Board Of The Serial-Controlled Ils - Federal Signal Corporation SpectraLux SIFZJ FSJoin Installation Maintenance And Service Manual

Selecting Configuration Options for the Serially-Controlled SIF
Selecting Configuration Options for the Serially-Controlled SIF
The serial controlled ILS has three configuration options that are selectable with DIP
switches on the light bar control board. The options are described in Table 1.

Figure 1 DIP switch locations the control boards of the serial controlled ILS (SIFM shown)

Table 1 Switch settings on the control board of the serial-controlled ILS

DIP Switch
Position
10
1 Not used
2 Not used
Activating a Front- or Rear-Mounted SIFM
3
• To activate a front-mounted SIFM: set Switch 3 OFF.
• To activate a rear-mounted SIFM: set Switch 3 ON.
4 Sets the ability to power the network cable for other devices. The default is OFF.
Switch 4 should only be set if the main power cables are turned on through an
ignition-activated relay. If powering other devices, such as the Six-Button Serial
Controller, set DIP Switch 4 to ON. For more information, see the instructions
included with the network-powered device.
SIFM, SIFZ (Discrete) and SIFMJ, SIFZJ FSJoin ™ (Serial) Front ILS Light Bar
Function
Federal Signal www.fedsig.com