With Temperature Control: Ambient Temperature Sensor Enabled - Invicta ARATOS P649000 Manual

With temperature control: ambient temperature sensor enabled


as in the example "Output Level 3"

If the recommended temperature is exceeded, the 3 LEDs will flash to indicate that the
temperature is being regulated, the output will decrease to Output Level 1 to avoid
overheating the room.


If the requested Output Level is 2, 2 LEDs will flash during output regulation, 4 LEDs will
flash if the requested Output Level is 4 etc...
Choose the maximum possible Output Level with the [Button B]:

In this example "Output Level 3": The stove will operate between levels 1 and 3 depending
on the difference between the desired temperature and the measured ambient temperature.
To turn off completely, press [button A]:

"Power On LED" starts flashing
Example 1: [button B] is set to Output Level 3, the temperature setting is 22°C, the stove will heat
at Output Level 3 until the measured room temperature reaches 22 °C and then, will automatically reduce to Output
Level 1 so as not to overheat the room.
Example 2: [button B] is set to Output Level 5, the temperature setting is 25°C, the stove will heat at Output Level 5
until the measured room temperature reaches 25 °C and then, will automatically reduce to Output Level 1 so as not
to overheat the room.
Please note:

The stove will not shut down automatically: It will remain at Output Level 1 even if the temperature setting is
exceeded.

In this case, if the heating requirements are lower than Output Level 1, the room temperature may continue
to increase . (in between seasons in particular)

Turn off the stove as necessary by pressing [button A].
XD, on 17/02/2020
ARATOS Plug-in
Recommended setting 15 to 30°C
Choose the required temperature setting with [button D]

in this example: 22 °C
The output indicators are lit at "maximum possible output"
stove
dual
Page 27 sur
model P649000
41