Moving Over From Logs To Pellets - Invicta ARATOS P649000 Manual

10 Moving over from logs to pellets:

To move over to using pellets:

Allow the wood to burn down to reduce the embers to a minimum.

Set the air regulators to using "wood pellets" (section 3.5)

Use a poker to flatten the embers in the crucible and check that pellet supply is not hindered by any wood.
(see diagram below)

Check that the ash pan has sufficient capacity to absorb the ash from combustion of the pellets contained in
the hopper.

Start the stove by pressing on button A for a few seconds:

Check that the pellets are properly alight after a few minutes.

Choose the operating mode = see 3.8
Changing over from using logs to pellets is a manual operation which requires intervention.
Keep an eye on the stove for around 30 minutes until certain that it is operating correctly with an
automatic supply of pellets.
XD, on 17/02/2020
ARATOS Plug-in
Important: area to clear with the poker so as not to
hinder the supply of wood pellets.
Risk of blocking the feed screw
"Power On LED" starts flashing
stove
dual
Page 30 sur
model P649000
41