Fujitsu AUXG36KRLB Service Manual page 168

¢ Local setting procedure
NOTE: Before performing the function setting, be sure to stop the operation of the air conditioner.
 Low noise mode
1. Press the MODE switch button (S134) for 3 seconds or more to switch to "Local setting mode".
2. After confirming the LED lamp of POWER/MODE blinks 9 times, press the ENTER switch but-
ton (S132).
3. Press the SELECT switch button (S133), and adjust the LED lamp as shown below. Then the
LED lamp indicates the current setting.
4. Press the ENTER switch button (S132).
5. Press the SELECT switch button (S133), and adjust the LED lamps as shown below.
6. Press the ENTER switch button (S132) and fix it.
7. To return to "Operating status display (Normal operation)", press the EXIT switch button
(S131).
In case of missing how many times you pressed the SELECT and ENTER switch buttons:
1. To return to "Operation status display (Normal operation)", press the EXIT switch button once.
2. Restart from the beginning of setting procedure.
NOTE: In case of missing how many times you pressed the SELECT and ENTER switch buttons,
you must redo the setting procedure. Return to "Operation status display (Normal opera-
tion)" by pressing the EXIT switch button once, and restart from the beginning of the setting
procedure.
1-2. Function settings on outdoor unit
PUMP
POWER
LOW NOISE
DOWN
ERROR
MODE
(L1) (L2)
Blinks
)
(9 times
Sign " ": Lights off
LOW NOISE
MODE
LOW NOISE
E
MOD
MODE 1: Low
MODE 2: Lower
MODE 1: Low
MODE 2: Lower
- (05-10) -
PEAK CUT
(L3) (L4) (L5) (L6)
LOW NOISE
(L3)
(L2)
Blink
LOW NOISE
(L2) (L3)
Sign " ": Lights on
PEAK CUT
(L4) (L5) (L6)
Blink
Blink
PEAK CUT
(L4) (L5) (L6)
1. Function settings