Module Is Easy To Damage; Ber(Bit Error Rate) Is High; Welding Instruction; Reflow Soldering Temperature - Ebyte E18 Series User Manual

Chengdu Ebyte Electronic Technology Co.,ltd.
lower the transmitting power；
Due to antenna quality or poor matching between antenna and module.


7.2 Module is easy to damage

Please check the power supply source, ensure it is between the recommended supply voltage, voltage higher than

the maximum will damage the module.
Please check the stability of power source, the voltage cannot fluctuate too much;

Please make sure antistatic measure are taken when installing and using, high frequency devices have electrostatic

susceptibility;
Please ensure the humidity is within limited range, some parts are sensitive to humidity;

Please avoid using modules under too high or too low temperature.


7.3 BER(Bit Error Rate) is high

There are co-channel signal interference nearby, please be away from interference sources or modify frequency and

channel to avoid interference;
Poor power supply may cause messy code. Make sure that the power supply is reliable;

The extension line and feeder quality are poor or too long, so the bit error rate is high.


8. Welding instruction

8.1 Reflow soldering temperature

Profile Feature
Solder Paste
Preheat Temperature min （Tsmin）
Preheat temperature max (Tsmax)
Preheat Time (Tsmin to Tsmax)(ts)
Average ramp-up rate(Tsmax to Tp)
Liquidous Temperature (TL)
Time（tL）Maintained Above（TL）
Peak temperature（Tp）
Aveage ramp-down rate（Tp to Tsmax）
Time 25℃ to peak temperature
Copyright ©2012–2019，Chengdu Ebyte Electronic Technology Co.,Ltd.
Curve characteristics
Solder paste
Min preheating temp.
Max preheating temp.
Preheating time
Average ramp-up rate
Liquid phase temp.
Time below liquid phase
line
Peak temp
Average ramp-down rate
Time to peak temperature
for 25℃
E18-MS1PA2-PCB User Manual
Sn-Pb Assembly
Sn63/Pb37
100℃
150℃
60-120 sec
3℃/second max
183℃
60-90 sec
220-235℃
6℃/second max
6 minutes max
Pb-Free Assembly
Sn96.5/Ag3/Cu0.5
150℃
200℃
60-120 sec
3℃/second max
217℃
30-90 sec
230-250℃
6℃/second max
8 minutes max
8-12