Parameters For Filling In The Package Fiche - Immergas MAGIS COMBO PLUS V2 Series Instructions And Recommendations For The Installer

4.5 PARAMETERS FOR FILLING IN THE
PACKAGE FICHE
Should you wish to install an assembly starting from the Magis
Combo Plus V2 package, use the package fiche shown in (Fig. 78).
For correctly filling in, enter the figures into the specific spaces (as
shown in the facsimile package fiche Fig. 77) found on the tables of
paragraphs "Parameters to fill in the low temperature package
fiche (30/35)", "Parameters to fill in the average temperature pack-
age fiche (47/55)".
Facsimile for filling in the package fiche for room central heating systems.
Temperature control
From temperature
control board
Supplementary boiler
From boiler board
Solar contribution
From the board of the solar device
Dimensions of the
manifold (in m
( 'III' x
climate conditions
climate conditions
Colder:
the heat loss in the distribution system and the size of the products compared to the size and
features of the building.
98
Class I = 1 %, Class II = 2 %,
Class III = 1.5 %, Class IV = 2 %,
Class V = 3 %, Class VI = 4 %,
Class VII = 3.5 %, Class VIII = 5 %
Volume of the
2 ) tank (in m 3 )
+ 'IV' x ) x 0.45 x (
G F E D
< 30 % 30 % 34 % 36 %
%
- 'V' =
The remaining values must be obtained from the technical data
sheets of the products used to make up the assembly (e.g. solar de-
vices, integration indoor unit, temperature controllers).
Use sheet (Fig. 78) "assemblies" related to the central heating
function (e.g.: heat pump + temperature controller).
Since the product is standard supplied with a tempera-
ture controller, the package fiche must always be com-
pleted.
(%)
( - 'I' ) x
tank
A* = 0.95, A = 0.91,
B = 0.86, C = 0.83,
manifold (in %)
D-G = 0.81
/ 100) x
C B A A
75 % 82 % 90 % 98 %
ter climate conditions
Hotter:
%
'I'
+
%
-
%
"II" =
+
%
=
%
+ ++ +++
A A
125 % 150 %
%
+ 'VI' =
77