Docking Station Installation - Redback MOWRO RM24 Operation Manual

Docking Station Installation

Avoid placing the docking station in a corner of the lawn or in low-lying
areas where the docking station or the Robot Mower may be damaged
by puddles, or under a high tree due to the risk of lightning.
Note: It is important that the adapter and the electrical plug are always
kept dry!
The docking station must have 6.5 feet of free space in front of it so the
Robot Mower can return to charge or when mowing is complete (see
Figure 3). The docking station must be located on level ground for correct
operation.
Connecting the Boundary Line to the Docking Station
Remove the terminal cover located on the back of the docking station. Insert the
end of the boundary wire into a blue T- clip and use a pair of pilers to press the
clip on the wire until you hear a click. Repeat this action on the other end of the
wire. Insert the wire that leaves the docking station into the negative (-) metal
prong. Connect the wire that comes from under the docking station to the
positive (+) metal prong. Proceed to plug in the docking station and confirm
the LED is a solid GREEN light. If the LED is flashing RED and GREEN confirm all
of your docking station connections are securely inserted and the boundary
wire does not have any cuts or breakage.
Figure 4
12
CLICK
IN
Figure 3
OUT