Docking Station Installation - Redback 107330 Operation Manual

Docking Station Installation

The docking station must be placed on a solid, flat surface.
Avoid placing the docking station in a corner of the lawn or in low-lying
areas where the docking station or the Robot Mower may be damaged
by puddles, or under a high tree due to the risk of lightning.
Note: It is important that the adapter and the electrical plug are always
kept dry!
The docking station must have 6.5 feet of free space in front of it so the
Robot Mower can return to charge or when mowing is complete (see
Figure 3). The docking station must be located on level ground for correct
operation.
Figure 3
Connecting the Boundary Line to the Docking Station
Strip 1/4" of plastic coating from either end of the boundary wire to
ensure a good connection. Remove the terminal cover on the back
of the docking station. Insert the boundary line ends into the docking
station (see Figure 4). Route the "IN" end of the boundary line beneath
the docking station and secure within the plastic brackets on the bottom
of the dock. Place the "IN" wire into the red terminal. After laying and
securing the boundary line, place the "OUT" end of the boundary wire
into the black terminal (see Figure 4). Secure the docking station to the
ground with four long ground stakes provided.
Black
Terminal
Detail of
Connection
Red
Terminal
Terminal
Red
Terminal
Black
Terminal
Back of the
Docking Station
Figure 4
9