Basic Connection And Configuration With The Cli; Connecting, Logging In, And Starting The Cli - Juniper J Series Quick Start Manual

J-series Services Router Quick Start

Basic Connection and Configuration with the CLI

1. Connecting, Logging In, and Starting the CLI

10 !
Basic Connection and Configuration with the CLI
4. To enable routing protocols, under Quick Configuration click Routing.
To add static routes, click Static Routing.
!
! To enable a routing protocol, click the protocol.
When you are finished with a page, click OK or Apply.
For complete instructions, see the J-series Services Router Basic LAN and WAN Access
Configuration Guide.
For CLI access, you connect from your management PC or laptop to the Services
Router through the console port. (For information about the CLI, see "JUNOS CLI
Basics" on page 14.)
You are prompted for a username and password. The default username is root .
Because no password is initially required, press Enter at the password prompt for a
first-time login.
To access a Services Router with the JUNOS CLI:
1. Turn off power to the management PC or laptop.
2. Connect one end of the console cable to the serial port adapter, plug the
adapter into a serial port on the PC or laptop, and plug the other end of the
cable into the console port on the Services Router.
3. Turn on power to the PC or laptop.
4. On the PC or laptop, start the terminal emulation program (such as Microsoft
Windows HyperTerminal), select the COM port, and configure the following port
settings: 9600 (bits per second), 8 (data bits), none (parity), 1 (stop bits), and
(flow control).
none
5. Press the POWER button on the router, and verify that the POWER LED turns
green.
6. Wait for the system to boot, and when presented with a login prompt, log in as
root , and press Enter at the Password prompt.
When you have been authenticated through the CLI, you enter the UNIX shell:
routername (ttyd0)
login: root
Password:
JUNOS 8.0R1 2006-07-01 01:59:49 UTC
root@%