Installing A J4300 Or J6300 Services Router; Installing A J4350 Or J6350 Services Router - Juniper J Series Quick Start Manual

To install a J2300 Services Router on a wall, attach the rubber feet to the chassis
underside, attach a mounting bracket to each side of the chassis, and attach the
brackets to the wall. (For instructions, see the J2300, J4300, and J6300 Services
Router Getting Started Guide.)

Installing a J4300 or J6300 Services Router

To install a J4300 or J6300 Services Router in a rack:
1. Make sure the rack is properly secured to the building in its permanent
2. Have one person grasp each side of the router, lift the router, and position it in
3. Have a second person install a mounting screw into each of the bracket holes

Installing a J4350 or J6350 Services Router

To install a J4350 or J6350 Services Router in a rack:
1. Make sure the rack is properly secured to the building in its permanent
2. Attach a screw to each rack rail in the third hole down from where you want the
3. Lift the router and insert the elliptical openings in the mounting brackets onto
Figure 3: Hanging the Router in the Rack
4. Install at least two mounting screws into each mounting bracket, in addition to
location.
the rack.
that are aligned with the threaded holes in the rack.
location.
top of the router to be positioned, as shown in Figure 3. Screw only part way in,
leaving about1/4 in. (6 mm) distance between the screw head and the rail.
the partially inserted screws so that the router is hanging from the two screws.
the center screws from which the router hangs.
J-series Services Router Quick Start
Front view
Front-mounting bracket
Rail
Center
Elliptical-hanger cutout
screw
Installing a Services Router
! 5