Operation - Rowenta VECTISSIMO CO180 Manual

NOT CD070025 CO180-185-190 12/06/07 10:30 Page 5
Please read carefully and keep in a safe place.
GB
1- WARNINGS
• For your safety, this appliance complies with the applicable standards and regulations or commercial (Low Voltage, Electromagnetic Compatibility, Environmental
Directives, etc.)
• The warranty will be invalid in the event of damage arising from incorrect use.
• Do not place your appliance directly beneath a wall socket.
• Do not operate your appliance in a dusty room or if there is a risk of fire.
• Each time before use, check that in general the appliance is in good condition, as well as the plug and the cord.
• Never insert any objects inside the appliance (e.g.: needles)
• If the power cord is damaged, it must be changed by the manufacturer, the After Sales Service or a similarly qualified person in order to avoid any danger.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure
that they do not play with the appliance.
• Do not pull the power cord or the appliance, even to unplug it from the wall socket.
• Completely unwind the cord each time before use.
• This product has been designed for domestic use only. Any commercial use, inappropriate use or failure to comply with the instructions, the manufacturer accepts no
responsibility and the guarantee will not apply.
2- VERY IMPORTANT
• NEVER COVER THE APPLIANCE, EVEN TEMPORARILY, AS THERE IS A DANGER OF OVERHEATING.
• Keep the appliance 50 cm away from any objects (curtains, walls, aerosols, etc.)
• NEVER USE IT TILTED OR LYING ON ITS SIDE.
• This appliance must not be used in damp places.
• Do not use this appliance near a bath, shower, sink or swimming pool.
• NEVER ALLOW WATER TO PENETRATE THE APPLIANCE.
• Do not touch the appliance with wet hands.
• In the event of a long absence : turn all the switches to the off position (light goes out) and unplug the appliance.
• Before plugging in the appliance, position the legs correctly (see diagrams no.5-6-7).
3- VOLTAGE
• Before using the appliance for the first time, ensure that your mains voltage corresponds to the voltage indicated on the appliance.
• Your appliance can be used with a power plug without an earth connection. It is a class II appliance (dual electrical insulation )
4- SAFETY
Heat safety
• In the event of abnormal overheating or if the appliance has tipped over, a safety device shuts down the appliance and then automatically restarts it once it has cooled.
If the fault persists or gets worse, a thermal fuse shuts the appliance down permanently and it must then be taken to an approved service centre.

5- OPERATION

Important: when you first use the appliance, there may briefly be a slight smell and smoke (classic phenomena on all new appliances; this will disappear after a few
minutes).
Starting up the appliance and choosing the operating mode:
• Power selection mod. CO 180
Your appliance provides a power of 2000 W.
Mod. CO 185 - 190
One Switch pressed and indicator light on :
- power 1000 W.
Both switches pressed and both indicator lights on :
- power 2000 W.
• Thermostat :
Adjust the temperature setting, according to your own comfort, by turning button (C) (fig. 1) :
- Setting 9 : opposite mark (G) : warmer
- Setting 1 : opposite mark (G) : cooler
• Frost-free setting :
This setting enables you to automatically maintain the temperature above 0°C in a normally insulated room, whose volume corresponds to the power of your appliance.
To do so, plug in your appliance, turn the button (C) so that the marker is opposite the " " symbol and press a power selection switch (E; indicator light on).
• Blower function (CO 190):
To reach the required temperature quickly, select the blower setting and full power.
6- CLEANING
• Your appliance must be unplugged before proceeding with any cleaning work.
• You can clean it with a slightly damp cloth.
• IMPORTANT: Never use abrasive products which might damage the appearance of your appliance.
• We recommend that you clean the air inlet and outlet grills at least once a year; (clean with a vacuum cleaner if necessary).
7- STORAGE
• When the storing your appliance, you can wind the cord around the stand and clip the end with the cord clip.
• It is important to allow the appliance to cool before winding the lead.
• When you are not using your appliance, store it in a dry place.
8- IN THE EVENT OF PROBLEMS
• Never dismantle your appliance yourself. A poorly repaired appliance may be dangerous for the user.
• Before contacting one of our Approved Service Centres (see enclosed list), ensure that:
- the appliance is set to normal operating mode;
- the air inlet and outlet grills are totally clear.
9- ENVIRONMENT PROTECTION FIRST !
Your appliance contains valuable materials which can be recovered or recycled.
Leave it at a local civic waste collection point