Very Important; Operation - Rowenta SPRINTO SO4010 Instructions For Use Manual

NOT 029671 Sprinto 28/04/03
Please read carefully and keep in a safe place.
1- WARNINGS
It is essential that you read these instructions carefully and comply with the following recommendations.
• This appliance complies with European directives 73/23/EEC and 89/336/EEC.
• Before using, always check the condition of the appliance, the power socket and the power lead.
• Do not pull on the power cable or the appliance, even to unplug it from the wall socket.
• Fully unwind the lead each time before use.
• Do not place the unit directly beneath an electrical outlet.
• If the unit is attached to a wall, the outlet must remain accessible.
• Never insert objects into the appliance (e.g. needles...).
• When in use, this appliance must be kept out of the reach of young children, animals and certain handicapped people.
• Do not use your appliance in a dusty room or a room where there is a risk of fire.
• This appliance is intended for domestic use only. It must therefore not be used in industrial applications.
• The warranty will be void in the event of damage arising from improper use.
• If the power cable is damaged, it must be replaced by the manufacturer, its after-sales service or a person with similar qualifications to avoid any danger.
• Disposal of product no longer suitable for use: Place the unit in specialised collection/refuse treatment centres.

2- VERY IMPORTANT

• WARNING: To avoid risk of overheating, NEVER PLACE OBJECTS ON TOP OF THE UNIT.
• Do not use this appliance near a bath, shower, sink or swimming pool.
• Do not use the unit in the proximity of flammable objects or products (curtains, aerosols, solvents, etc.)
• This appliance must not be used in damp places.
• Never use the unit in an inclined or horizontal position.
• NEVER ALLOW WATER TO PENETRATE THE APPLIANCE.
• Do not touch the appliance with wet hands.
• In the event of a long absence: turn the button A (3) to the initial setting
3- VOLTAGE
• Before first use, make sure that the voltage being used corresponds to what is indicated on the unit and that the electrical installation is adapted
to the power level indicated.
• Your appliance can be used with a power plug without an earth connection. It is a class II appliance (dual electrical insulation
4- SAFETY
Mod. SO4010:
• In the event of abnormal overheating, a safety device shuts down the appliance and then automatically restarts it once ithas cooled. If the fault persists
or gets worse, a thermal fuse shuts the appliance down definitively and it must then be taken to an approved service centre.
Mod. SO4020:
• In the event of abnormal overheating, a safety device shuts down the appliance and then automatically restarts it once ithas cooled. If the fault persists
or gets worse, a thermal fuse shuts the appliance down definitively and it must then be taken to an approved service centre.
• If the unit tips over, a safety device automatically turns it off. When placed back in an upright position, it will once again begin to operate.
In both cases, a warning beep will occur and the "Signal-Protect" indicator (D) will light up.

5- OPERATION

Before turning the unit on, make sure:
it is positioned as described in these instructions,
that it is placed in a flat and horizontal position, and;
that the air intake and outlet screens are free of all obstacles.
• Function Selection :
Select the desired function by turning switch (A) to line up the marking on the switch with one of the following symbols:
: on
: Cooling
• : 1200W
• • : 2400W
• Indicator:
- On/Off indicator C (3), lights up when the unit is turned on.
"Signal Protect" indicator D (3b), lights up in case of overheating or if the unit tips over. Only for Mod.SO4020.
• Thermostat:
Adjust the temperature setting, according to your own comfort, by turning button B (3).
• Frost-free setting :
This setting enables you to automatically maintain the temperature above 0°C in a normally insulated room, whose volume corresponds to the power of your
appliance.
Plug in the unit and turn switch B to line up the marking on the switch with the "
• 1200W or •• 2400W
• Cold ventilation setting :
This setting enables you to use your fan heater as a fan in summer.
11:18 Page 7
and unplug the appliance.
" symbol and turn switch A to select one of the following:
GB
).
MAX MIN