Operation - Rowenta CLASSIC SO9110 Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 10
• However, the electrical installation in the room, the installation of the unit and the way the unit
is used must all comply with the safety standards in force in your country.
• WARNING : Do not use this heater in small rooms when they are occupied by persons not capable
of leaving the room on their own, unless constant supervision is provided.
• CAUTION : Some parts of this product can become very hot and cause burns. Particular attention
has to be given where children and vulnerable people are present.
3 - VOLTAGE
• Before first use, make sure that the voltage being used corresponds to what is indicated on the
unit and that the electrical installation is adapted to the power level indicated.
• Your appliance can be used with a power plug without an earth connection. It is a class II appliance
(double insulation
4 - SAFETY
• In the event of abnormal overheating, a safety device shuts down the appliance and then
automatically restarts it once it has cooled. If the fault persists or gets worse, a thermal fuse shuts
the appliance down completely and it must then be taken to an approved service centre.

5 - OPERATION

Before turning the unit on, make sure:
• it is positioned as described in these instructions,
• that it is placed on a flat and horizontal surface, and;
• that the air intake and outlet grilles are free of all obstacles.
• Function Selection :
Select the desired function by turning switch A (3) to line up the marking on the switch with one of
the following symbols:
: OFF
: 1000W
: 1800W
• Indicator:
- On/Off indicator C (3), lights up when the unit is turned on.
• Thermostat:
Adjust the temperature setting, according to your own comfort, by turning
button B (3).
• Frost-free setting
This setting enables you to automatically maintain the temperature above 0°C in a normally
insulated room, whose volume corresponds to the power of your appliance.
Plug in the unit and turn switch B (3) to line up the marking on the switch with the "
and turn switch A (3) to select one of the following:
1000W or
1800W.
).
:
EN
" symbol
11

Advertisement

Table of Contents
loading

Table of Contents