Placa De E/S - Dell Latitude 3500 Service Manual

Next steps
1. Replace the battery cable.
2. Replace the base cover
3. Replace the SD memory card
4. Follow the procedure in

Placa de E/S

Removing the IO board
Prerequisites
1. Follow the procedure in
2. Remove the SD memory
3. Remove the base cover.
4. Remove the battery.
5. Remove the hard drive
NOTE: Required for systems with 42 Whr battery
Steps
1.
NOTE: Removing the I/O board also removes the coin-cell battery which resets the CMOS settings.
Open the latch and disconnect the I/O board cable from the system board [1].
2. Peel the I/O-board cable from the palm rest and keyboard assembly [2].
3. Remove the two (M2x3) screws that secure the I/O board to the palm rest and keyboard assembly [1].
4. Lift the I/O board, along with the cable, off the palm rest and keyboard assembly [2].
after working inside your computer
before working inside your
card.
assembly.
computer.
Retirar e instalar componentes 27