Changing The Blade; Storage; Disposal /Enviromental Protection - Grizzly ERM 1500-33 LF Translation Of The Original Instructions For Use

GB
• Always keep the equipment
clean. To clean, use a brush or
cloth but no detergent or solvent.
• After mowing, use a piece of
wood or plastic to remove ad-
herent plant remains from the
wheels, ventilation holes, ejec-
tion hole and blade area. Do not
use hard or pointed objects, as
these may damage the blade.
• Oil the rollers from time to time
• Before each use, check the lawnmower
for obvious defects such as loose, worn
or damaged parts. Check that all nuts,
bolts and screws are sitting firmly.
• Check the covers and protective de-
vices for damage and check that they
are sitting correctly. Replace them if
necessary.

Changing the Blade

If the blade is blunt, it can be sharpened
by a specialist workshop. If the blade
is damaged or showing signs of imbal-
ance, it must be replaced (see chapter on
"Spare Parts").
1. Turn the equipment over.
2. Use sturdy gloves and hold the
blade (19) firmly. Loosen the
blade bolt (17) with the supplied
spanner (4).
3. Install the new blade (19) in the
reverse order. Ensure that the
blade is positioned correctly and
the screw (20) tightened firmly.

Storage

Clean the equipment before putting it
away (see "General Cleaning and Mainte-
nance Work").
68
In order to ensure that the device
takes up less space, unlock the
clamping lever (2) and fold down
the bow-type handle (1). Make
sure that the cable of the device
(11) is not pinched.
• Keep the equipment dry and out of
reach of children.
• Allow the motor to cool before storing
the equipment in a confined space.
• Do not cover the equipment with nylon
bags as moisture could build up.
We will not be liable for damages caused
by our equipment where these are caused
by improper repair or the use of non-
original parts or by use other than for the
intended purpose.
Disposal /Enviromental
Protection
Do not dispose of used oil in the sewage
system or drains. Dispose of used oil in
an environmentally correct manner - bring
it to a waste disposal center. Be environ-
mentally friendly. Return the tool, acces-
sories and packaging to a recycling
when you have finished with them.
Machines do not belong with do-
mestic waste.
The plastic and metal parts employed can
be separated out and thus recycled use
can be implemented. Ask our Service-
Center for details.
Defective units returned to us will be dis-
posed of for free.
centre