Trouble Shooting - Grizzly ERM 1500-33 LF Translation Of The Original Instructions For Use

GB

Trouble Shooting

Problem
Equipment does not
start
Motor stops
Result unsatisfactory or
motor labours
Blade fails to turn
Strange noises, rattling
or vibrations
Poor air cushion
70
Possible Cause
Power is off
Defective on/off switch
Worn carbon brushes
Defective motor
Grass too long
Blockage by foreign ob-
ject
Cut height too low
Blade blunt
Blade area blocked
Blade assembled incor-
rectly
Blade blocked by grass
Blade screw loose
Blade screw loose
Blade damaged
Clogged air filter
Severely clogged under-
side of the machine
Fault Fixing
Check the socket, cable, wire
and plug and have any repairs
carried out by an electrician
Repair by customer services
Set a greater cut height. Lift the
front wheels slightly by pressing
down on the handle bar
Remove the foreign object
Set a higher cut height
Have the blade sharpened or
replace it
Clean the equipment
Install the blade correctly
Remove the grass
Tighten the blade screw
Tighten the blade screw
Replace the blade
Cleaning the air filter (see „Gene-
ral cleaning and maintenance")
Cleaning the machine (see
„General cleaning and mainte-
nance")