Connect Heated Hoses - Graco Gusmer Power-Lock 246045 Instructions - Parts Manual

Installation

Connect Heated Hoses

WARNING
Read warnings, pages 6 and 7.
1. Lay heated hoses end to end, matching the
color coding. Red for component A (ISO),
blue for component B (RES).
F . 2
IG
2. Connect fluid hoses (A, B).
F . 3
IG
Do not connect the main air supply to
the air hose at this time.
Common insulated heated hoses do not
contain an air hose.
10
B
A
TI2678B
A
B
TI2679B
3. Connect air hoses (C).
D
F . 4
IG
4. Connect electrical wires.
a. Ensure electrical wires ends are 5/8 in.
(0.625mm) long. If they are not, use a
sharp scissors to strip all four wire ends
to the correct length. See Strip Length
Gauge for correct length.
Strip Length
This illustration is not to scale.
F . 5
IG
Be careful not to cut or nick copper
strands. If more than five strands are cut
or nicked, trim wire and re-strip.
New hoses are pre-stripped at correct
length; remove insulation to expose bare
wire.
D
C
TI2682B
5/8 in.
(0.625 mm)
TI9733a
309572S