Table of Contents
Advertisement
Setting an indoor unit address and installation option
14. Setting Dry mode
Press Mode button to be change to Dry mode in the OFF status.
15. Setting SEG18, SEG20 option
Press Low Fan button( ) to enter SEG18 value.
Press High Fan button( ) to enter SEG20 value.
Each time you press the button, ... will be selected in rotation.
16. Setting Fan mode
Press Mode button to be change to Fan mode in the OFF status.
17. Setting SEG21, SEG22 option
Press Low Fan button( ) to enter SEG21 value.
Press High Fan button( ) to enter SEG22 value.
Each time you press the button, ... will be selected in rotation.
18. Setting Heat mode
Press Mode button to be change to HEAT mode in the OFF status.
19. Setting SEG23, SEG24 mode
Press Low Fan button( ) to enter SEG23 value.
Press High Fan button( ) to enter SEG24 value.
Each time you press the button, ... will be selected in rotation.
Step 3. Check the option you have set
After setting option, press
Step 4. Input option
Press operation button
For the correct option setting, you must input the option twice.
Step 5. Check operation
1. Reset the indoor unit by pressing the RESET button of indoor unit or outdoor unit.
2. Take the batteries out of the remote controller and insert them again and then press the operation button.
28
DVM S NASA_Global 4-WC_사우디향_IM_EN_04191A.indd 28
Option setting
button to check whether the option code you input is correct or not.
with the direction of remote control for set.
Status
SEG18
SEG21
SEG23
SEG20
SEG22
SEG24
2013-11-05 오전 11:30:32
Advertisement
Table of Contents
