Troubleshooting - Bissell ADAPT ION XRT 3034 Series User Manual

Troubleshooting

WARNING
To reduce the risk of fi re, electric shock or injury, turn power OFF and disconnect plug from electrical
outlet before performing maintenance or troubleshooting.
Problem Possible causes
Battery isn't fully charged
Vacuum
Wrong charger is being used
won't turn on
Vacuum Brush Roll stalled by debris
won't turn on
and LED light
is solid RED
Brush Roll is jammed
Brush Roll
not turning
Brush Roll needs to be reset
Dirt Tank is full
Dirt Tank isn't installed properly
Foot is loose
Vacuum
Filters need cleaning
cleaner
has low
suction
Filters need replacing
Clog or obstruction in foot area
Dirt Tank is full of debris
Visible dirt Filter Assembly is missing or
installed incorrectly
escaping
from vacuum
Dirt Tank installed incorrectly
Wrong charger is being used
Vacuum
won't charge
Hand Vacuum may not be
installed in place properly
14
www.BISSELL.ca
Remedies
Charge battery; follow charging
battery instructions on page 5
Be sure to use only the charger
supplied with your product; the label
on the detachable hand vacuum will
list which charger can be used
Clear the Brush Roll and Brush Roll
End Cap area; follow instructions on
page 12
Remove obstruction; follow
instructions on page 12
Follow instructions on page 12
Empty Dirt Tank
Position Dirt Tank correctly and
snap firmly into place
Make sure foot is fully inserted into
body of unit
Follow Filter cleaning instructions on
page 11
Visit www.BISSELL.ca or call
1-800-263-2535 to order
replacement Filters
Detach foot from main body and
examine and remove clog
from opening
Empty Dirt Tank
Check Filter for correct installation
Position Dirt Tank correctly and
snap firmly into place
Use only the charger that comes with
the machine
Remove the Hand Vacuum and
install it properly