Setup; Inspect The Cutting Unit; Using The Kickstand When Tipping The Cutting Unit - Toro Reelmaster 3100-D Series Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
Media and Additional Parts
Description
Parts Catalog
Operator's Manual
O-ring
Screws
Note: Determine the left and right sides of the machine
from the normal operating position.
1

Inspect the Cutting Unit

Parts needed for this procedure:
1
Cutting unit
Procedure
After the cutting unit is removed from the box, inspect the
following:
1. Check each end of the reel for grease. Grease should
be visible in the reel bearings and internal splines of
the reel shaft.
2. Ensure that all nuts and bolts are securely tightened.
3. Make sure that the carrier frame suspension operates
freely and does not bind when it is moved back and
forth.
Description
Cutting unit
No parts required
No parts required
No parts required
Fixed plate kit (not included)
Qty.
1
–
–
–
1
Qty.
1
Review the materials and keep them in an appropriate
place.
1
1 Use these when mounting reel motor to cutting unit.
2 Use these to mount reel motor to cutting unit.
2
Using the Kickstand When
Tipping the Cutting Unit
No Parts Required
Procedure
Whenever you have to tip the cutting unit to expose the
bedknife/reel, prop up the rear of the cutting unit with the
kickstand (supplied with the traction unit) to make sure that
the nuts on the back end of the bedbar-adjusting screws are
not resting on the work surface
4
Use
Inspect the cutting unit.
Use the kickstand when tipping the
cutting unit.
Adjust the rear shield.
Mounting the counterweights.
Install the fixed plate kit (optional).
Use
(Figure 3).