Table of Contents
Advertisement
Quick Links
TWENTY6 FI
DIRECT VENT LOG SET KIT
PART #: LGS-26FI
INSTALLATION MANUAL
ONLY FOR USE ON SÓLAS MODELS: FIN-36N, FIN-36P
WARNING
This log set kit shall be installed by a qualified service agency in accordance with
the manufacturer's instructions and all applicable codes and requirements of the
Authority Having Jurisdiction. If the information in these instructions is not
followed exactly, a fire, explosion or production of carbon monoxide may result
causing property damage, personal injury or loss of life. The qualified service
agency is responsible for the proper installation of this kit. The installation is not
proper and complete until the operation of the converted appliance is checked as
specified in the manufacturer's instructions supplied with the kit.
NOT FOR USE WITH VENT FREE OR OUTDOOR FIREPLACES
0
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Solas TWENTY6 FI
Summary of Contents for Solas TWENTY6 FI
- Page 1 TWENTY6 FI DIRECT VENT LOG SET KIT PART #: LGS-26FI INSTALLATION MANUAL ONLY FOR USE ON SÓLAS MODELS: FIN-36N, FIN-36P WARNING This log set kit shall be installed by a qualified service agency in accordance with the manufacturer’s instructions and all applicable codes and requirements of the Authority Having Jurisdiction.
- Page 2 LOG SET INSTALLATION Kit Contents: • (3) Ceramic Logs • (2) Ceramic Rocks • 13oz Lava Rock • Metal Logset burner FIGURE 01 Step #1 FIGURE 02 Your fireplace will have shipped from the factory with the Glass Media burner in place, before installing the logset burner, we need to remove the glass burner.
- Page 3 LOG SET INSTALLATION FIGURE 04 Step #3 To remove the burner from the fireplace, slide the entire assembly to the right before lifting up to remove as shown in figure 04. Step #4 Once the glass media burner has been removed, locate the Logset burner included in the kit LGS-26FI as shown in figure 05.
- Page 4 LOG SET INSTALLATION Step #5 Install the logset burner within the firebox by lowering the burner into the firebox (while keeping the burner pressed toward the right side of the firebox) then sliding the burner left towards the center of the firebox to engage the burner orifice as shown in figure 08.
- Page 5 LOG SET INSTALLATION Step #8 Install the single rock on the 2 pins located on the far left of the burner top. The log-locating tab on top of the rock should be toward the back of the burner. (Figure 10) FIGURE 10 Step #9 Install the center birch log by placing the left side of the log on the locating pin left of the pilot.
- Page 6 LOG SET INSTALLATION Step #11 Using the log-locating tab on the single rock on the left side of the burner, rest the small birch log on the rock and align with the leading edge of the burner as shown in figure 13. FIGURE 13 Step #12 The Y-log should be located as shown, begin by referencing the left side of the log between the 3-rock...
Need help?
Do you have a question about the TWENTY6 FI and is the answer not in the manual?
Questions and answers