Synchronisation Gate Time (06. Menu Item) - Datcon DT9100 I4 Operating Instructions Manual

Function
Sequence of operations 1. Enter the menu by typing in the supervisor code.
Exit from the menu item 1. After finishing the setting, press the MENU button to exit
Exit from the menu
36

Synchronisation gate time (06. menu item)

7.8.
The setting of the pulse width of the remote
synchronisation signal. When the active state of the
synchronising current is lower then this value the
instrument will not accept it as a synchronisation signal
(this function is useful for filtering a false value caused by
noise). The active state of the input is 12 mA or higher
loop-current.
When the input is in active state the clock stops (and you

will see the
the input goes to inactive state (I = 8 mA), the clock starts
(and you will see the time on the display).
The way the code should be typed in is described in
Chapter 7.1. Type in the code (password). You will see on

the display:
2. Keep stepping by pressing the ▲ button until the menu

item .
3. Enter the menu item by pressing the ENTER button.
4. You will see the actual gate time on the display, and the
first digit will be blinking.
5. By pressing button ▲ you can set the pulse width
between 1 and 8 seconds.
the menu item, and you will see this:
(2. If you want to change the setting you have just done, or
if you just want to check what you have typed in, go on with
the operation from point 3 of the Sequence of
operations.)
(3. If you don't want to exit the menu, as you want to do
further settings, then you may select the desired menu
items by pressing the ▲ button.)
1. Press the MENU button. First the mnemonic

(Save), then the mnemonic
are shown on the display. With this the storing of
the settings is completed. The instrument has
exited the menu and goes on with the
measurement.
2.
mnemonic on the display), and when
.

DT9100 I4
.

(Exit)
20180905-V120180905