Table of Contents
Advertisement
48
10.4. Messages of critical errors
Such errors are caused normally by structural injuries or
damages. Repair is done by the service of Datcon. In case
of error it is recommended to notice of the displayed error
message, as well as of the phenomenon seen and
communicate to the Datcon service personnel.
Default Factory Settings (Service: Default Factory
Settings)
The instrument needs to be re-calibrated, and the operating
parameters have also got damaged.
Repairing: by service
The last saving was not successful (Error: Last Save)
Saving of the parameters modified last time was
unsuccessful. The error was caused most probably by an
interruption of the current loop. The status prior to the
modification was preserved.
Repairing: Enter the menu, check the parameters. Change
the incorrect values to the desired values, then exit the
menu in the regular way. Pay attention to ensure that the
loop current should not get interrupted during the operation
.
DT9100 I4
20180905-V120180905
Advertisement
Table of Contents
