Table of Contents
Advertisement
Function
Sequence of operations 1. Enter the menu by typing either the user code or the
32
7.5. User code (03. menu item)
You can define new codes instead of the factory-defined
user code. The code is an optional number within the range
between 0000 and 9999.
[Default factory setting: 0000]
supervisor code.
The way the code should be typed in is described in
Chapter 7.1. Type in the code (password). You will see
this:
.
2. Keep stepping by pressing the ▲ button until the menu
item
appears.
3. Enter the menu item by pressing the ENTER button.
4. You see on the display:
The digit on the left side is blinking.
•
By pressing the ▲ button you can increase the value of
the blinking digit:
,
,
,
,
,
•
By pressing the ► button you can select the next digit.
3. By pressing the buttons ▲ and ►, type in the new user
code.
4. Press the MENU button.
5. You have to type the new code in twice. This prevents
an error in defining the new code due to typing mistakes.
This is indicated by the mnemonic
6. By pressing the buttons ▲ and ► type in the new user
code again.
7. Press the MENU button.
8. When the code you wrote in for the first time is not
identical with the code written in for the second time, a
blinking mnemonic
and the device exits the menu item. You will see this
on the display. (The user code has not changed,
the old one is valid.) Restart the operation from Point 3.
.
,
,
,
,
, etc.
warns you about the error,
DT9100 I4
(re-type).
20180905-V120180905
Advertisement
Table of Contents
