TESTO 926 Instruction Manual page 10

30 5. Operation
OFF was selected:
Continue with objective
On was selected:
Use
2
threshold ( ) and confirm with
Use
3
threshold ( ) and confirm with
3
To r r egister t t he r r adio p p robe:
Radio probes may only be used in countries in which
they have been Type Approved (see application infor-
mation of the radio probe).
The setting function for radio probes is only available if
a radio module (accessory part) is inserted into the
measuring instrument.
See the chapter
If no radio module is inserted:
Continue with objective
Each radio probe has a probe ID (RF ID). This consists of
the last 3 digits of the serial no. and the position of the
slide switch in the radio probe (H or L).
Configuration mode is opened and RF ID and Auto are
lit.
The radio probe is switched on and the transfer rate is
set to 2 readings per second (see application infor-
mation of the radio probe).
Select the desired option with
1
:
· YES: Switches automatic probe detection on
(recommended).
· no: Switches automatic probe detection off.
no was selected:
Use
2
confirm with
/ to set the value for the upper alarm
/ to set the value for the lower alarm
C
OMMISSIONING
/ to set the probe ID manually and
.
T
O REGISTER THE RADIO PROBE
.
.
.
T A O
O SET UTO FF
and confirm with
.
.