Table of Contents
Advertisement
Rear Frame Bracket Assembly & Installation
Before installing the Rear Frame Bracket, first remove the existing hitch and its hardware located at the rear end of
the mower and set it aside (Refer to Figure A). Next, remove the two bolts located on either side of the hitch kit that
was just removed.
To install the Rear Frame Bracket (Item #1), position the Rear Frame Bracket over the rear end of the mower aligning
all of the lower bolt holes of the Rear Frame Bracket to those on the mower's rear end. Secure the Rear Frame
Bracket to the mower by replacing the existing hitch removed from earlier and using (4) 5/16"-18 x 1" Carriage Bolts
(Item #3) and (4) 5/16"-18 Ny-Flange Lock Nuts (Item #4). Refer to Figure B.
Secure the Rear Frame Bracket (Item #1) to the Side Frame Brackets by using (4) 5/16"-18 x 1" Carriage Bolts (Item
#3) and (4) 5/16"-18 Ny-Flange Lock Nuts (Item #4). Refer to Figure B.
Leave the hardware Loose on the Right Side Frame Bracket for the installation of the Mount Arm Assembly, all other
hardware maybe tightened at this time.
Figure A
Figure B
Side Frame
Bracket
8
Rear End View
Remove Existing Hardware
From Lower Rear End of Mower
8
8
Side Frame Bracket
Hitch
Advertisement
Table of Contents
