Boot Kit Installation; Blower Cone Installation - Peco 54120901 Operator's Manual

Boot Kit Installation

Secure the Boot Plate P#(B1049) to the Aluminum Boot P#(E0035A) using (2) 3/8"-16 x 1" Carriage Bolts P#(K1182)
and (2) 3/8"-16 Nylon Flange Locknuts P#(K2038). Insert the bolts from the inside so that the threads are on top of the
boot. This will prevent grass clippings from collecting on the bolt threads. Leave the hardware loose until the boot
assembly has been attached to the mower deck. Lift the grass deflector and position the boot plate between the two
tabs. Secure the boot plate by using (1) Boot Rod P#(B0288) and (1) Hair Pin Clip P#(K0099) Close any gaps
between the boot and the mower deck by adjusting the position on the boot in the boot plate slots. Tighten all
hardware at this time. Refer to Figure A.
Figure A
Aluminum
Boot
Boot
Plate
(2) 3/8"-16 x 1"
Carriage Bolts
(2) 3/8"-16 Locknuts

Blower Cone Installation

Align the bolt holes of the 8" Blower Cone (Item#1) to the bolts holes located on the Blower Housing of the PTO
Assembly. Secure the 6" Blower Cone to the Blower Housing by using (3) 1/4"-20 x 3/4" HHCS (Item#2), (3) 1/4"
Lock Washers (Item#3), and (3) 1/4" Flat Washers (Item#4). Refer to Figure B.
Blower Housing
Figure B
20