Swivelling The Cutter Bar; Attach The Shoulder Strap; Switching On And Off - Parkside PTHSA 20-Li A2 Translation Of The Original Instructions

Swivelling the cutter bar

D
1. Hold the blade safety bar (1) on the
bottom of the motor head (2).
2. Press the release button ( 3).
3. Swivel the motor head (2) with the
blade safety bar (1) into the desired
angular position and release the re-
lease button ( 3). The motor head (2)
locks back into place again. There are
11 possible positions.
The latching steps are indi-
cated on the device
housing. The current lat-
ching step is indicated by
an arrow.

attach the shoulder strap

The carrying strap (
equipped with a quick-acting
release mechanism so that the
device can be released quick-
ly from the carrying strap in a
dangerous situation. To open
the push-fit lock (
press the two clamps (
together.
1. Put on the shoulder strap. Do not wear
the shoulder strap across the chest.
2. Attach the shoulder strap spring clip
( 13) to the carrying eyelet (
A
the tubular shank of the device.
3. Set the strap length such that the spring
clip ( 13) on the shoulder strap (
A
is roughly at the height of your hip.
A
12) is
12a),
A
12b)
A
9) on
A
12)
A
You can vary the position of the car-
rying eye (9). Loosen the carrying eye
(9) using the enclosed hexagon socket
wrench (19) and slide it along the
tube to the desired location.
Then refasten the carrying eye (9).
The hexagon socket wrench (19) can
be found on the handgrip next to the
battery insertion point.
Remove/insert battery
1. To remove the battery (
device, press the release button on the
battery and pull the battery out.
2. To insert the battery (
battery along the guide rail into the de-
vice. You will hear it click into place.
Observe the safety information
and notes on proper use in the
separate instruction manual for
your Parkside X 20 V Team
series rechargeable battery.

Switching On and Off

Ensure that you are standing in a
firm position with both hands grip-
ping the hedge trimmer away from
the body. Ensure that the trimmer is
in contact with no other objects be-
fore switching on.
1. To switch on, hold the safety switch
( 10) depressed and simultaneously
A
press the on/off switch (
vice will be run at maximum speed.
2. The equipment will switch off again
when you release on/off switch (
GB IE NI
15) from the
A
15), push the
A
11). The de-
A
11).
A
13