Before Use; Motor Unit; Attaching The Round Handle; Fixing/Attaching The Shoulder Strap - Parkside 378345 2110 Translation Of The Original Instructions

■ The device is designed for two-handed opera-
tion. Never work with one hand.
■ Make sure that the appliance is switched off
when relocating the appliance and that you
cannot accidentally touch the On/Off switch.
Carry the appliance with the blade facing back-
wards. Fit the blade guard during transporta-
tion.

Before use

WARNING! RISK OF INJURY!
► Pull out the mains plug before carrying out
any work on the tool.
Risk of electric shock!

Motor unit

Attaching the round handle

♦ Fit the round handle 5 in the desired position
on the boom 3.
♦ Tighten the screw 4.

Fixing/attaching the shoulder strap

♦ Hook the shoulder strap k into the carrying
lug 6.
♦ Adjust the length of the shoulder strap k to
your size so that the carrying lug 6 is at hip
height when the strap is hooked in place.

Fitting the hedge trimmer

♦ Push the front boom o of the hedge trimmer
onto the boom 3 of the motor unit.
♦ The locking pin p must engage.
♦ Screw the two booms 3 o together with the
tommy screw 1.

Mounting the boom

♦ Push the boom f onto the boom 3 of the
motor unit.
♦ The locking pin g must click into place.
♦ Screw the two booms 3 f together with the
tommy screw 1.
PHSL 900 B4

Swivelling the hedge trimmer

♦ Undo the lock/release t.
♦ Press the control lever u and swivel the hedge
trimmer into the desired position.
♦ Allow the control lever u and the lock/
release t to click into the recess in the base
plate (hedge trimmer) z.

Setting up

NOTE
► Comply with regulations regarding noise
protection and local rules. Using the appli-
ance on certain days (e.g. on Sundays and
public holidays), during certain times
(midday, night time) or in certain locations
(e.g. health resorts, clinics, etc.) may be
restricted or prohibited.
Switching on/off
Switching on
♦ Connect the mains cable q to the extension
cable.
♦ Form a loop at the end of the extension cable
and hang it in the strain relief w.
♦ Press the safety lock-out 9 and keep it pressed;
then press the On/Off switch 0. You can now
release the switch-on lock 9 again.
Switching off
♦ Release the On/Off switch 0.
♦ Remove the extension cable from the strain
relief w.
♦ Disconnect the mains cable q from the exten-
sion cable.

Adjusting the handle

♦ Press the release button 8. Turn the swivel
element 7 to the desired position. Let go of the
release button 8; it must click into place.
GB │ IE │ 9 ■