Advertisement
The Metro-MH machine electrical system
includes an alternator which generates
high electrical voltages. Do NOT operate
the machine without all safety covers in
place, covering all wiring and electrical
equipment and devices.
!
DO NOT TOUCH ELECTRICAL SYSTEM
COMPONENTS,
AND/OR
SOCKETS.
VOLTAGES MAY BE PRESENT EVEN
WHEN POWER IS OFF.
1. Do NOT alter the electrical wiring in
any way without receiving prior written
approval
and
2. The lighting tower is NOT a mobile
generator set. It should only be used
for
its
intended
3. The hydraulically operated mast has
hazardous crushing/pinch points. Do
NOT put arms, hands etc. near the
mast structure while it is in operation.
4. Do not operate the lights within easy
reach of people's hands. Lamp fixtures
become hot during operation. Lamp
fixtures can remain hot for some time
after the lights have been switched off.
5. Do NOT replace lights with alternative
lights without being authorised by JLG.
6. The mast is not a crane. Do NOT
attempt to lift any object by using or
modifying or altering the mast and/or
the lighting tower hydraulic system.
7. There are moving parts in and around
the engine and alternator area of the
unit.
Prior
to
maintenance checks or accessing the
engine area, ensure unit's engine is
shut-down and the mast retracted.
Section 1
METRO-MH
SAFETY PRECAUTIONS
LAMP
TERMINALS
DANGEROUS
advice
from
JLG.
design
purpose.
carrying
out
any
Page 1-4
Become familiar with all machine controls
and the machine's operating envelope,
prior to operating the machine. The
machine's mast uses a hydraulic/wire rope
system to lift and lower the mast.
1. Before raising the mast, ensure that
the ground is suitable to support and
level the machine, particularly under
each of the outrigger pads.
2. Mechanical damage will result if the
machine's mast is allowed to strike
external structures such as buildings
etc.
!
FAILURE OF THE OUTRIGGERS TO
SUPPORT THE MACHINE ON SOFT
SURFACES
COULD
MACHINE TO TIP OVER. NEVER RAISE
THE MAST FULLY WITHOUT FIRST
SETTING ALL FOUR (4) OUTRIGGERS
AND
ENSURING
TOWER IS LEVEL. A BUBBLE LEVEL
IS MOUNTED AT THE FRONT OF THE
MACHINE NEAR THE BASE OF THE
MAST TO AID IN LEVELLING OF THE
MACHINE.
!
DO NOT ERECT OR OPERATE THE
MACHINE IN CONDITIONS WHERE THE
WINDSPEEDS ARE LIKELY TO EXCEED
100 km/hr.
TIPPING OR OVERTURNING OF THE
LIGHTING TOWER IS POSSIBLE.
CAUSE
THE
THE
LIGHTING
1001206598
Advertisement
