Advertisement
!
DO NOT USE THE JOCKEY WHEEL TO
SUPPORT THE MACHINE WHEN THE
MAST IS RAISED. PRIOR TO RAISING
THE MAST, CHECK AND ENSURE
THAT NO OVERHEAD OBSTRUCTIONS
EXIST.
10. Raise the mast to desired elevation by
operating the enable and lift control
toggle switches simultaneously.
11. Adjust the lighthead tilt angle by
operating the enable and tilt control
toggle switches simultaneously.
12. Adjust the angle lighthead rotation to
desired angle by operating the enable
and rotate control toggle switch while
simultaneously.
!
TO AVOID CRUSHING INJURIES, REMAIN
CLEAR
OF
MOVING
SECTIONS AND LIGHTHEAD.
TURNING-ON THE ENGINE/LIGHTS
CONTROLLER MODULE
BEFORE OPERATING THE CONTROLLER,
RELEASE THE EMERGENCY-STOP.
WHEN THE BATTERY IS CONNECTED, THE
CONTROLLER BOOTS IN AUTO-MODE.
PRESS THE CONTROLLER
TO INITIATE CONTROLLER "STAND-BY"
MODE.
Section 1
METRO-MH
MACHINE OPERATION
TOWER
MAST
BUTTON
Page 1-16
1001206598
Advertisement
