Jandy AquaPure Ei Series Instructions

Replacement Kit Instructions
Jandy AquaPure
®
FOR YOUR SAFETY - For anything other than the routine cleaning and maintenance described
in this manual, this product must be serviced by a contractor who is licensed and qualified in
pool equipment by the jurisdiction in which the product will be installed where such state or
local requirements exists. In the event no such state or local requirement exists, the installer
or maintainer must be a professional with sufficient experience in pool equipment installation
and maintenance so that all of the instructions in this manual can be followed exactly. Before
installing this product, read and follow all warning notices and instructions that accompany
this product. Failure to follow warning notices and instructions may result in property damage,
personal injury, or death. Improper installation and/or operation will void the warranty.
Improper installation and/or operation can create unwanted electrical hazard which can cause
serious injury, property damage, or death.
These instructions are to be used with the following Jandy Replacement Parts:
R0511100 -- R-Kit, Power Pack, 120V Plugged Version
1. Introduction
This document gives instructions for replacing
the power pack on the Jandy AquaPure Ei chlorine
generating device.
The instructions were written with safety as the
priority and must be followed exactly. Not following the
written procedure or taking shortcuts may increase the
risk of personal injury. Read through the instructions
completely before starting the procedure.
For technical assistance, please contact our
Technical Support Department at 1.800.822.7933.
2. Ordering Information
To order or purchase parts for the Jandy AquaPure
Ei chlorine generating device, contact your nearest
Jandy dealer or distributor. If they cannot supply you
with what you need, call Zodiac Pool Systems, Inc. at
1.800.822.7933. In Canada call Zodiac Pool Systems
Canada, Inc. Customer Support Department at
1.888.647.4004.
Ei Series Replacement Kits
®
TM
for Models APURE35PLG/35PLGC
WARNING
3. Replacing the Power Pack
Disconnect power to the system by uplugging
the power pack before performing this procedure
to avoid risk of electric shock which can result in
property damage, severe injury or death.
Figure 1.
WARNING
Power Pack, 120V
Plugged Version
(R0511100)
Power Pack R-Kit