Table of Contents
Advertisement
Vess A6000 Series Storage Appliance for Video Surveillance
M
anageMent
This section describes how to establish a management connection the Vess A6000 subsystems. Management
through the Gigabit network connection is done using Promise Management GUI, a web browser based GUI.
network ConneCtion
Vess A6000 have two Gigabit Ethernet RJ-45 ports on the rear panel for connection to an Ethernet network.
Use this connection with Promise Management GUI to login as the device administrator.
To establish the management path:
1. Attach one end of an Ethernet cable to the network connector or standard NIC in the Host PC.
Attach the other end of the Ethernet cable to one of the ports on the standard network switch.
2. Attach one end of an Ethernet cable to one of the ports on the standard network switch.
Attach the other end of the Ethernet cable to either 1GbE network port on the Vess A6000 system.
(See illustration below for port location)
If you have multiple Vess A6000 systems, Host PCs or Servers, repeat steps 1 and 2 as required.
3. Follow the instructions for managing the basic settings of the Vess A6000.
p
C
atH
onneCtIon
24
Introduction
Advertisement
Table of Contents
