Table of Contents
Advertisement
Promise Technology
i
2.5" d
nStalling
The instructions below apply 2.5" hard disk drives installed in drive carriers intended for use with models Vess
A6600 and Vess A6800.
1. Remove a disk drive carrier.
2. Carefully lay the disk drive into the drive carrier at the front, so that the screw holes on the bottom of the
carrier line up correctly with the power and data connectors facing away from the carrier handle.
3. Insert the screws through the holes on the bottom of the drive carrier and into the bottom of the disk drive.
Install only the counter-sink screws supplied with the drive.
•
Install four screws per drive.
•
Snug each screw. Be careful not to over-tighten.
4. Reinstall the drive carrier into the enclosure.
Repeat steps 1 through 3 until all of your disk drives are installed.
d
c
iSk
rive in tHe
arrier
23
Product Manual
Advertisement
Table of Contents
