Table of Contents
Advertisement
1. If the DHCP server is available, you can check to automatically obtain an IP address and
other network settings from that server.
2. The valid value range of Maximum Transmission Unit (MTU) is 500 ~ 9676.
3. The Multicast sends a stream to the multicast group address and allows multiple clients
to acquire the stream at the same time by requesting a copy from the multicast group
address.
4. Before utilizing this function, you have to enable the Multicast function of your router
and configure the gateway of the network.
5. If the DNS server settings are required for some applications (e.g., sending email), you
should properly configure the Preferred DNS Server and Alternate DNS server.
6. The router must support the route advertisement function if you select Route
Advertisement as the IPv6 mode.
PPPoE: If you have no router but only a modem, you can use Point-to-Point Protocol over
Ethernet (PPPoE) function. Click this button to enable the PPPoE function,
Select this option to configure your Network Camera to make it accessible from anywhere as
long as there is an Internet connection
Note that to utilize this feature, it requires an account provided by your ISP.
Follow the steps below to acquire your Network Camera's public IP address.
1. Set up the Network Camera on the LAN.
2. Go to Home > Configuration > Application > Server Settings to add a new email or FTP
34
Advertisement
Table of Contents
