Safety Instructions - Brinkmann STA1005 Operating Instructions Manual

2.3 Technical data

3 Safety instructions

Type Type
STA1005/ 530
630
760
880
STA1006S 610 SAL1006S 630
710
840
960
1) Depth of immersion SAL = h + 0.78 Inches (20 mm)
2) Weight SAL = g + 2.2 lbs (1 kg)
3) Noise emissions measured in accordance with DIN 45635 at a distance of 39.37 Inches (1 m).
The motor is surface-cooled and compliant with
DIN IEC 34 and EN 60034 (protection degree IP 55).
When operating the pump, the safety instructions con-
tained in this manual, the relevant national accident
prevention regulations and any other service and
safety instructions issued by the plant operator are to
be observed.
3.1 Hazards in the event of non-compliance with
the safety instructions
Non-compliance with the safety instructions may pro-
duce a risk to the personnel as well as to the environ-
ment and the machine and results in a loss of any
right to claim damages.
For example, non-compliance may involve the follow-
ing hazards:
• Failure of important functions of the machines/plant
• Failure of specified procedures of maintenance and
repair
• Exposure of people to electrical, mechanical and
chemical hazards
• Endangering the environment due to hazardous
substances being released
3.2 Unauthorized modes of operation
• Pump may not be used in potentially explosive en-
vironments!
• Pump and discharge piping are not designed to hold
any weight and may not be used as a step ladder.
BAS6502
Max. del. Max.
pressure del. volume
spec. weight 1
PSI bar GPM
157 10.8 385
182 12.5 385
730
860
980
Edition
Height Depth of
H immersion
1)
Inches STA h
l/min mm Inches
1450 36.0 20.87 530
914 24.80 630
29.92 760
34.65 880
1450 38.3 24.02 610
974 27.95 710
33.07 840
37.80 960
3.3 Remaining Risk
Risk of Injury!
Risk of squeezing or crushing body parts when in-
stalling or removing the pump exists. Proper and se-
cured lifting tools must be used.
Risk of burns!
The pump must have cooled down sufficiently prior to
commencing any repair, maintenance or installation.
3.4 Qualification and training of operating per-
sonnel
The personnel responsible for operation, maintenance,
inspection and assembly must be adequately qualified.
Scope of responsibility and supervision of the person-
nel must be exactly defined by the plant operator. If the
staff does not have the necessary knowledge, they
must be trained and instructed, which may be per-
formed by the machine manufacturer or supplier on be-
half of the plant operator. Moreover, the plant operator
is to make sure that the contents of the operating man-
ual are fully understood by the personnel.
04/2020
Weight Power
2)
STA
g HP
mm lbs kg kW
379 172 23.0
386 175 17.3
395 179
425 193
445 202 25
454 206 18.5
465 211
474 215
Page 3 of 11
Noise level
3)
STA
dBA / 60
Hz
79
80