/ spec. dBA / 50 Type weight 1 l/min H mm h mm l mm SBA141 0.63 / 0.725 SBA142 1.1 / 1.27 SBA143 1.7 / 1.95 SBF125 28.5 0.63 / 0.725 1) Noise emissions measured in accordance with DIN 45635 at a distance of 1 m.
Safety instructions relevant for operation 5 Installation and Connection • If hot or cold machine components involve Mechanical installation hazards, they must be guarded against acci- The pumps must be properly fastened. The pipe- dental contact. work must be installed so that no distortion of the •...
Electric wiring 6 Start up / Shut down Start up ATTENTION Switch off at the mains. All service work must be carried out by quali- After connection the electrical wires, close the fied service personnel. Pump must be discon- terminal box. Briefly start the motor (max. 30 sec.) nected from the power source and all rotating and check the rotation according to the arrow on parts must stand still.
8 Servicing and Maintenance Pumps with double mechanical seal (-GD) Pumps with double mechanical seal (-GD) are ATTENTION identified by the letters GLRD stamped in on the motor side of the pump foot and must include an oil The surface of the motor must be kept free of dirt. receiver with a capacity of 0.24 litres.
10 Spare part 10.1 Spare part list for Brinkmann Horizontal End-Suction Pumps Series SBA141…143, SBF125 Item Description Item Description Stator with terminal board 30 Shaft seal Motor flange 31 Compensation disk 1.7 kW End shield 50 Pump body Terminal box...
(24a) from the 1. Pumptype pump body (50) and pump foot (12). Clean the e.g. SBA141 seat of the seal and the pump parts! 2. Pump No. The mechanical seal (24) should now be com- e.g.
Mark the first screw and tighten all the screws evenly by hand, one after the other in a clock- wise direction (not cross-ways). − Tighten the shaft clamp ( 24 mm) for SBA141, SBA142 and SBF125 Use a torque screwdriver to tighten each screw first with 1.3 Nm then with 2.6 Nm and finally...