3.5-Inch Hard Drive; Removing The 3.5-Inch Hard Drive - Alienware AURORA R11 Service Manual

Steps
1. Align the hard drive with the pins on the hard-drive carrier.
2. Using the tabs on the opposite side, flex open the carrier to insert the pins on the other side.
3. Slide the hard-drive assembly into the hard-drive cage until it snaps into place.
4. Connect the data cable and power cable to the hard drive.
NOTE: Repeat the steps to install any additional 2.5-inch hard drive from your computer.
Next steps
1. Install the left-side cover.
2. Follow the procedure in

3.5-inch hard drive

Removing the 3.5-inch hard drive

Prerequisites
1. Follow the procedure in
2. Remove the left-side cover.
About this task
The following images indicate the location of the 3.5-inch hard drive and provides a visual representation of the removal procedure.
After working inside your
Before working inside your
computer.
computer.
21