Table of Contents
Advertisement
L. POWER TILT/SEAT ELEVATE
COMBO OPERATION
(Standard operating instructions)
!
WARNING
Make sure the power
wheelchair is on a
level
surface
before proceeding
with either Tilt or Elevate
mode and drive in reduced
speed while elevated.
LEVEL SURFACE
Tilt and Seat Elevate options are programmed to operate
separately. The ability to tilt while the seat elevator is elevated
is not possible. Bypassing this programming may cause
severe injury.
1. DUAL ACTUATOR TOGGLE SWITCH
Increasing/decreasing seat height
Pull the toggle switch (located next to the wheelchair
joystick) backwards until the desired height is achieved,
then release. To change direction, release the toggle switch
to the neutral position for at least 1 second, and pull the
toggle switch backwards in the same direction until you
achieve the desired height, then release.
Increasing/decreasing tilt angle
Push the toggle switch (located next to the wheelchair
joystick) forward until the desired tilt angle is achieved,
then release. To change direction, release the toggle switch
to the neutral position for at least 1 second, and push
the toggle switch forward in the same direction until you
achieve the desired tilt angle, then release.
30
2. DRIVING IN REDUCED SPEED
Reduced drive speed is a feature designed to allow the
user to drive the wheelchair at a reduced speed while
elevated up to 11" (280 mm). When elevated, the drive
speed is then reduced to 25% of its original setting. Full
drive speed is achieved when the seat elevate is down to its
lowest position.
3. DRIVE LOCK-OUT
Drive lock-out is a safety feature designed to prevent the
power wheelchair from being driven while in a tilt angle
over 15° relative to the horizontal position.
DANGER
Never operate the wheelchair while in tilt mode over
15° relative to the horizontal position. Never operate
the seat elevate when the wheelchair is on any slope.
In reduced speed, the power wheelchair must be driven
on a level surface. If the drive lock-out does not stop the
wheelchair from operating when in a tilt angle
over 15°, or if it allows the seat elevate to elevate
while tilted, or if the reduced speed does not slow
the wheelchair's drive speed to 25% of
its original settings, have it or the power
seat elevate system serviced by
an authorized
supplier or
qualified technician.
M. POWER TILT
OPERATION
(Standard operating instructions)
!
WARNING
Make sure the power wheelchair
is on a
level surface
before
proceeding with Tilt mode.
LEVEL SURFACE
FOUR-WAY TOGGLE
Increasing tilt angle
A
Push the four-way toggle switch
forward until the desired tilt angle
is achieved and release.
Decreasing tilt angle
B
To reverse the tilt angle direction,
release the four-way toggle switch
to the neutral position for at least
1 second and push the four-way
toggle switch forward until the
desired tilt angle is achieved
and release.
PUSH BUTTON SWITCHES
Increasing tilt angle
Push the 1
st
button (furthest from
the wire) until the desired tilt
angle is achieved and release.
Decreasing tilt angle
To reverse the tilt angle
direction, release the 1
button
st
to the neutral position for at
least 1 second and
push the same button until the
1
push button
st
desired tilt angle is achieved
and release.
&
A
B
A
B
A
B
31
Advertisement
Table of Contents
