Configure The Firewall Policies - Fortinet FortiWiFi FortiWiFi-60 Installation And Configuration Manual

Using a wireless network

Configure the firewall policies

FortiWiFi-60 Installation Guide
5 Enter a key or pre-shared key depending on the Security Mode selected.
6 Select the MAC Filter tab.
7 Enable MAC filtering if desired.
8 Enter the MAC addresses and select to Add or Deny them from the wireless network.
Note: You will need to distribute the information entered in step 2 and step 5 with the wireless
users so they can connect to the wireless network.
The FortiWiFi-60 unit provides WAN interfaces for Internet connections. You can
configure the Internet connection for both wired networks on the internal and/or DMZ
interfaces and the wireless network through the WLAN interface.
You can provide secure Internet access for wireless clients by creating firewall
policies from the WLAN interface to the WAN1 or WAN2 interfaces.
The following example creates a policy from the wireless clients (WLAN interface) to
the Internet (WAN1 interface) using traffic shaping, firewall authentication and the
default Strict content policy.
To create a new wall policy for a secure Internet connection
1 Go to Firewall > Policy.
2 Select the blue arrow for WLAN to WAN1.
3 Select Create New.
Configure the following settings:
Interface/Zone Source
Interface/Zone
Destination
Address Name Source
Address Name
Destination
Schedule
Service
Action
NAT
Protection Profile
4 Select Advanced.
5 Select Authentication.
6 Type the user name or group name.
7 Select Traffic Shaping
8 Configure traffic shaping bandwidth and Traffic Priority settings to meet your
requirements.
9 Select OK.
WLAN
WAN1
All
All
Always
ANY
ACCEPT
Enable
Strict
01-28008-0030-20050128
Setting up the FortiWiFi-60 as an Access Point
39