To Connect the Power Supply
1. Connect the supplied Wall adapter to the Wall Adapter Connector (J230)
The Wall Adapter Connector is located to the left of the Developer Board On/Off switch
(labeled Power ) at the rear of the Developer Board.
2. Plug the adapter into a wall outlet.
Note:
Wall-mount
Adapter Connector
Figure 2-3: Developer Board Power Switch and Adapter Connector (Rear)
Serial Communications
USB and RS232 serial interfaces are available for communicating with a PC. The G24-L
Developer's Kit includes the necessary RS232 and USB cables for connecting to a PC.
To Connect Serial Communication Cables
•
Connect
RS232-1 connector (J300), or the supplied Mini-AB USB cable to the USB connector (J380).
The RS232 and USB connectors are located to the right of the Developer Board On/Off
switch (labeled Power ) at the rear of the Developer Board.
Audio Devices
The G24-L Developer's Kit has connectors that support the following audio devices:
•
Headset (supplied)
•
Microphone
•
Speaker
•
Alert Speaker
To Connect Audio Devices
•
Connect the supplied headset to the appropriate connector, labeled HEADSET
on page
The Audio Connectors are located on the left side of the Developer's Board.
September 25, 2007
The G24-L Developer Board can also be powered by an external DC power supply. This
option is described in
"Configuration" on page
Charger model.
Power
Indicator LED
Developer Board
On/Off Switch
(Figure
2-3) either the supplied RS232 cable with a male D-type connector to
10)
G24-L Developer's Kit
Chapter 2: Developer Board and Interfaces Description
12. This option do not apply to G24-L
(Figure
2-3).
(Figure 2-4,
9