Initial Setup; Connecting The G24-L - Motorola G24-L Technical Information

Initial Setup

This section describes the initial procedure for setting up the Developer Board for G24-L testing
and evaluation. The tasks in this section need to be performed only once, prior to initial use of the
Developer's Kit. After performing the initial setup, you can modify the default settings or use
different peripheral devices, as described in
Perform the steps in this section in sequence.
Before starting, remove the cover of the Developer Board. The cover simply slides up off the
board, and does not require the removal of any screws or clips. After setting up the Developer
Board, replace the cover simply by pushing it gently back into place. Make sure the cover is
aligned properly with the external connectors on the side of the board.
Note:

Connecting the G24-L

To Connect the G24-L to the Developer Board
1. Place the G24-L
push the G24-L 70-pin connector down into the G24-L 70-pin connector on the Developer
Board.
The two screw holes on the G24-L should be aligned with the G24-L spacers (denoted by M2
and M3).
2. Fasten the G24-L to the Developer Board using the two M2 screws provided with the kit.
3. Connect the internal RF cable MMCX connector to the MMCX connector of the G24-L by
pushing it in until it clicks
4. Insert the External Antenna Connector into the dedicated hole in the Developer Board cover
and close nut.
5. Connect the external RF cable between the External Antenna Connector and the Internal
Antenna Connector
This connects the G24-L to the antenna.
September 25, 2007
Numbers that appear in parentheses throughout the following paragraphs (Jxxx, Sxxx,
etc.), refer to components reference designation numbers as they are given on the
developer board and in the schematic diagrams.
(Figure 2-2) on the Developer Board area, marked by a white rectangle, and
(Figure
(Figure 2-2).
G24-L Developer's Kit
Chapter 2: Developer Board and Interfaces Description
"Configuration" on page
2-2).
2-12.
7