Motorola G24-L Technical Information page 85

2. Attach the DC input connectors to the Developer Board (see
Note:
3. Connect the battery power leads to the power connectors and the battery temperature sense
lead to ADC3 (Pin 47) of the Developer's Board header connector.
4. Verify that the correct power source - P204 (P.S power jumper) is selected (see
Figure C-2: Battery Connections
To Connect the Wall-mount Adapter
1. Connect the supplied Wall-mount adapter to the Mini-AB USB connector (J380) (see
Figure
Note:
2. Connect the Wall-mount adapter into a wall outlet.
September 25, 2007
The DC input connectors are not included and should be purchased separately. Use the
red connector for VCC and the black one for GND.
DC Power
Connector
ADC3
(Pin 47)
C-3).
The Mini-AB USB connector is located to the right of the Developer Board On/Off
switch (Labeled USB) at the rear of the Developer Board.
G24-L Developer's Kit
Appendix C: G24-LC (Charger Model)
Figure C-2).
External
Battery
Figure C-2).
C-3