Renkus-Heinz Varia VA101-7 User Manual page 11

Signal/Limit
LED Status Indicator
Analog/AES Input
& Looping Output
XLR female & XLR Male
PowerCON TRUE1 power
input and loop out.
Maximum loop out current,
The input panel shown is for the SA1250 digital bi-amplifier used in the self-powered VA models.
Amplifier Control Knob Functions
PRESS TO SELECT
Quick presses of the knob will select which parameter to adjust: INPUT, VOLUME, or PRESETS.
TURN TO EDIT
Once a parameter selection has been made turn the knob counter-clockwise to decrease values, turn the knob clockwise to
increase values.
PRESS/HOLD for 2 seconds TO SAVE
When selecting an input or a preset, confirmation is needed to save the input, or load the preset. Press and hold the control
knob for 2 seconds to save an input, or load a pre-set. The display will flash when the input has been selected, or the preset has
loaded.
PRESS / HOLD for 10 seconds TO RESET
In order to assist with troubleshooting the loudspeaker or amplifier, we have included a reset function. This reset function clears
all user memory, wipes any DSP settings in working memory and recalls preset 00, bringing the unit back to its factory settings.
Press and hold the knob for 10 seconds to initiate the reset. The display will turn off, the loudspeaker will reboot.
For information on remote control and networking please refer to the Renkus-Heinz RHAON II User's Manual.
RHAON II Empowered VARIA Array Module Connections
20 amps
Point Source Array Modules
Amplifier Control Knob
See below for details on
functions
Network Connections
Primary & Secondary
On -RN versions, the sec-
ondary is a "loop out," work-
ing as a two-port switch.
On -RD versions, the sec-
ondary is for a redundant
network connection or it can
be configured as a "loop
out." This configuration is
done using Dante Controller.
11