Load Label Roll In Rewind Mode; Load Transfer Ribbon - Carl Valentin Compa II 103/8 T Quick Reference Manual

Load Label Roll in Rewind Mode

In rewind mode the labels are wound up internally after printing for later use.
•
Guide the label strip around the deviating shaft (4) to the internal rewinder (2).
•
Hold the rewinder (2) firmly and turn the knob (3) clockwise until it stops.
•
Push the label strip under a bracket (1) of the rewinder and turn the knob (3) counter clockwise until it stops.
•
Turn the rewinder (2) counter clockwise to tighten the label strip.
•
Turn the lever (5) clockwise to lock the printhead.

Load Transfer Ribbon

NOTICE!
For the thermal transfer printing method it is necessary to load a ribbon, otherwise when using the printer in direct
thermal print it is not necessary to load a ribbon. The ribbons used in the printer have to be at least the same width
as the print media. In case the ribbon is narrower than the print media, the printhead is partly unprotected and this
could lead to early wear and tear.
NOTICE!
Before a new transfer ribbon roll is loaded, the printhead must be cleaned using printhead and roller cleaner
(97.20.002).
The handling instructions for the use of Isopropanol (IPA) must be observed. In the case of skin or eye contact,
immediately wash off the fluid thoroughly with running water. If the irritation persists, consult a doctor. Ensure
good ventilation.
English
Compa II
105